E10K Commands:

Title:E10K Commands:
Author:Douglas O’Leary <dkoleary@olearycomputers.com>
Description:E10K Commands:
Date created:08/1999
Date updated:09/1999
Disclaimer:Standard: Use the information that follows at your own risk. If you screw up a system, don’t blame it on me...

Domain specific commands

bringup

Sets the h/w config, configures the centerplane if needed, runs POST, loads and starts OBP, and starts the netcon_server

-f Don’t check to see if domain is already running. Will crash a running domain

-A {on|off} Toggles the auto-boot? OBP parameter. -C Forces configuration of the centerplane. Any running domains will crash -l {7-15} Diagnostic level; 7 takes a long time; 15 will take forever.

check_host
No description
hostinfo

Provides detailed system status information

-F Provides fan status
-S Provides CPU signature information
-h Provides detailed CPU information
-p Provides system component power status
-t Provides system temperature information
hpost
No description
netcontool
No description
power

Directs the control board to change the system power state:

-on Turns on power -all Apply power to everything: full cmd: power -on -all -off Turns off power -B Turns off power to everything: Full cmd: power -B -off -sb [n n# n## ...] Apply action to specific system boards -s Turn on/off selected power supplies -p Turn on/off specific power distribution units

sigbcmd
No description
sys_clock
No description
sys_id

(Re)Creates or checks the domain eeprom.image file.

-f eeprom.image.${domain_name} Resulting output filename -k ${key} Domain key that SUN provides -s ${serial} Domain serial number used to create the first domain -h ${hostid} Hostid that SUN provides used to create additional domains -d Confirms proper eeprom.image file creation

sys_reset
No description
netcon
No description
hostint
No description
hostreset
No description
drview
No description
netcon_server
No description
drain
No description
reconfig
No description